Machine

Pipe bending machine Rollers made of 8 kinds for square pipe: 15×15mm, 20×20mm, 25×25mm, 30×30mm, 40×40mm, 50×50mm, 60×60mm, 70×70mm. Suitable for bending all kind of round steel or stainless steel pipes with thickness not bigger than 2mm.

Always clean up the rollers well before using stainless steel not to get the pipe contaminated.

RAISING CAPACITY, INCREASE IN PRODUCTION

El-C3 pipe bending machine raises the bending capacity and makes it more simple and practical the bending adjustment which turns it into an increase in production and easy handling.It’s composed by a piston, a hydraulic group and a positioning detection system which makes it an easy-to-handle set even after the machine has been bought. It’s ideal for the repetition of pieces thanks to its position sensor.

Manufacturer of Pipe Bending Machine

Ellsen Machinery Factory is a large professional manufacturer and trade integration enterprise who is devoted and engrossed in developing, producing construction machines and wrought iron craft equipments.

As a professional pipe bender manufacturer, Ellsen provides good quality pipe bending machine with affordable price. If you have a demand for hydraulic pipe bending machine, welcome to contact us.

Rebar bender and rebar cutter is common in building industry.rebar bender also has two type: GW42 rebar bender and GW50 rebar bender.

1.In accordance with processing steel diameter and rebar bender specification ,you must installed mandrel,molding shaft,shaft stop,variable block frame.and mandrel diameter is 2.5 times steel diameter.
2.Using the steel bar bending machine,according to the specification requirement,did processing the diameter exceed 6-40mm or 6-50mm,also add the oil is not allowed.
3.Need bend the low alloy steel and high hardness steel ,change the mandrel and max diameter are best choose.
At ordinary time ,machine attendance is importance,if you did use the machine ,please put it away,and and the oil in time.

if you has other questions in the course of using,please tell me ,we can send our engineer to help you.you maybe worry spare part questions,if you according to the specification ,our machine can meet you requirement,usually,we advice our client to buy easily damaged part.

Electric tamping rammer is made of pure copper motor,it adopts impaction and vibration for tamping ground, so it is widely used in Road and other tamping area,Studying the operation methods is necessary,the following is my operation experience

◆Pre-operating Preperation

1. Please read the manual carefully, and grasp it’s main points.
2. Please ensure that the bolts and every part of the rammer are fastened every time before operating the rammer.
3. Please ensure that the lubricating oil is adequate every time before operating the rammer
4. Please ensure that the ground wire line of the electromotor is earthed and the insulated wire line is safe and intact.

◆During operating

1. Please operate the rammer on the level and compact ground.
2. You can control the working condition of the rammer by control switch of the electromotor after starting the electromotor
3. Do not hold down the handrail strongly so as not to affect the bounce height of the rammer.
4. By rotating the handrail, you may not only make the rammer move forward as required, but make it rotating at the original place.

Welcome to China, Welcome to visit us! You will get high quality rebar processing, wrought iron machine and road machinery with competitive price and good service from us!